Configures the specified interface.
Step 4 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-if-list)# interface Bundle-Ether 200
Configures the specified interface.
Step 5 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring PWHE Interfaces
Perform this task to configure PWHE Ethernet and interworking interfaces, that is, to attach the generic
interface list with a PWHE Ethernet and interworking interfaces.
SUMMARY STEPS
1. configure
2. interface pw-ether id or interface pw-iw id
3. attach generic-interface-list interface_list_name
4. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 interface pw-ether id or interface pw-iw id
Example:
RP/0/RSP0/CPU0:router(config)# interface pw-ether <id>
or
RP/0/RSP0/CPU0:router(config)# interface pw-iw <id>
(interface pw-ether id) Configures the PWHE pseudowire main or subinterface and enters the interface configuration
mode.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
294
Implementing Multipoint Layer 2 Services
Configuring PWHE Interfaces
To Next Page
Loading...
Need help?
General
