Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group bg1
Enters Layer 2 VPN VPLS bridge group configuration mode for the named bridge group.
Step 8 bridge-domain bridge-domain-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bd1
Enters Layer 2 VPN VPLS bridge group bridge domain configuration mode for the named bridge domain.
Step 9 igmp snooping disable
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# igmp snooping disable
Disables IGMP snooping for the current bridge domain.
Step 10 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuration Examples for Multipoint Layer 2 Services
This section includes these configuration examples:
Multipoint Layer 2 Services Configuration for Provider Edge-to-Provider Edge:
Example
These configuration examples show how to create a Layer 2 VFI with a full-mesh of participating Multipoint
Layer 2 Services provider edge (PE) nodes.
This configuration example shows how to configure PE 1:
configure
l2vpn
bridge group 1
bridge-domain PE1-VPLS-A
interface TenGigE0/0/0/0
vfi 1
neighbor 10.2.2.2 pw-id 1
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
321
Implementing Multipoint Layer 2 Services
Configuration Examples for Multipoint Layer 2 Services
To Next Page
Loading...
Need help?
General
