SUMMARY STEPS
1. configure
2. l2vpn
3. tcn-propagation
4. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3 tcn-propagation
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# tcn-propagation
Allows TCN propagation from minor ring to major ring and from MSTP to G.8032.
Step 4 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring Flow Aware Transport Pseudowire
This section provides information on
Enabling Load Balancing with ECMP and FAT PW for VPWS
Perform this task to enable load balancing with ECMP and FAT PW for VPWS. Creating a PW-Class in
L2VPN configuration leads to load-balancing.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
286
Implementing Multipoint Layer 2 Services
Configuring Flow Aware Transport Pseudowire
To Next Page
Loading...
Need help?
General
