Cisco ASR 9000 Series

• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring Dynamic Point-to-Point Cross-Connects
Perform this task to configure dynamic point-to-point cross-connects.
For dynamic cross-connects, LDP must be up and running.
Note
SUMMARY STEPS
1. configure
2. l2vpn
3. xconnect group group-name
4. p2p xconnect-name
5. interface type interface-path-id
6. neighbor A.B.C.D pw-id pseudowire-id
7. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3 xconnect group group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group grp_1
Enters the name of the cross-connect group.
Step 4 p2p xconnect-name
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
107
Implementing Point to Point Layer 2 Services
Configuring Dynamic Point-to-Point Cross-Connects