Cisco ASR 9000 Series Configuration Guidelines

Specifies the interface type ID. The choices are:
• GigabitEthernet
• TenGigE
Step 6 neighbor ipv4 ip-address pw-id number
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor ipv4 26.26.26.26 pw-id 100
Configures a pseudowire for a cross-connect.
Step 7 pw-class pw-class-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p-pw)# pw-class L2TPV3_V4_CLASS
Enters pseudowire class submode to define a name for the cross-connect.
Step 8 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring L2TPv3 Encapsulation and Protocol
Perform this task to configure L2TPv3 encapsulation and protocol.
SUMMARY STEPS
1. configure
2. l2vpn
3. pw-class class-name
4. encapsulation l2tpv3
5. protocol l2tpv3
6. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
168
Implementing Point to Point Layer 2 Services
Configuring L2TPv3 Encapsulation and Protocol

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model