Cisco ASR 9000 Series Configuration Guidelines

ethernet ring g8032 RingA
port0 interface g0/0/0/0
port1 interface g0/1/0/0
instance 1
description BD2-ring
profile ERP-profile
rpl port0 owner
vlan-ids 10-100
aps channel
level 3
port0 interface g0/0/0/0.1
port1 interface g1/1/0/0.1
# Set up the bridge domains
bridge group ABC
bridge-domain BD2
interface Gig 0/0/0/0.2
interface Gig 0/1/0/0.2
interface Gig 0/2/0/0.2
bridge-domain BD2-APS
interface Gig 0/0/0/0.1
interface Gig 1/1/0/0.1
# EFPs configuration
interface Gig 0/0/0/0.1 l2transport
encapsulation dot1q 5
interface Gig 1/1/0/0.1 l2transport
encapsulation dot1q 5
interface g 0/0/0/0.2 l2transport
encapsulation dot1q 10-100
interface g 0/1/0/0.2 l2transport
encapsulation dot1q 10-100
interface g 0/2/0/0.2 l2transport
encapsulation dot1q 10-100
Configuring Interconnection Node: Example
This example shows you how to configure an interconnection node. The following figure illustrates an open
ring scenario.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
344
Implementing Multipoint Layer 2 Services
Configuring Interconnection Node: Example

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model