Cisco ASR 9000 Series

pw-class class2
encapsulation mpls
load-balancing flow-label both
!
xconnect group group1
p2p p1
interface TenGigE 0/0/0/0.1
neighbor 1.1.1.1 pw-id 1
pw-class class1
!
!
!
This sample configuration shows how to enable load balancing with FAT PW for VPLS.
For VPLS, the configuration at the bridge-domain level is applied to all PWs (access and VFI PWs). Pseudowire
classes are defined to override the configuration for manual PWs.
Note
l2vpn
pw-class class1
encapsulation mpls
load-balancing flow-label both
bridge group group1
bridge-domain domain1
vfi vfi2-auto-bgp
autodiscovery bgp
signaling-protocol bgp
load-balancing flow-label both static
!
!
!
!
bridge-domain domain2
vfi vfi2-auto-ldp
autodiscovery bgp
signaling-protocol ldp
load-balancing flow-label both static
!
!
!
!
!
Configuring Pseudowire Headend: Example
This example shows how to configure pseudowire headend.
Consider the topology in the following figure.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
347
Implementing Multipoint Layer 2 Services
Configuring Pseudowire Headend: Example