Name: Cisco ASR 9000 Series
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

DETAILED STEPS

Step 1 configure

Example:

RP/0/RSP0RP0/CPU0:router# configure

Enters the configuration mode.

Step 2 l2vpn

Example:

RP/0/RSP0RP0/CPU0:router(config)# l2vpn

Enters L2VPN configuration mode.

Step 3 pw-oam refresh transmit seconds

Example:

RP/0/RSP0RP0/CPU0:router(config-l2vpn)# pw-oam refresh transmit 100

Enables pseudowire OAM functionality..

The refresh transmit interval ranges from 1 to 40 seconds.

Note

Step 4 endorcommit

Example:

RP/0/RSP0RP0/CPU0:router(config-l2vpn)# end

RP/0/RSP0RP0/CPU0:router(config-l2vpn)# commit

Saves configuration changes.

• When you issue the end command, the system prompts you to commit changes:

Uncommitted changes found, commit them before exiting(yes/no/cancel)?[cancel]:

• Entering yes saves configuration changes to the running configuration file, exits the configuration session, and

returns the router to EXEC mode.

• Entering no exits the configuration session and returns the router to EXEC mode without committing the

configuration changes.

• Entering cancel leaves the router in the current configuration session without exiting or committing the

configuration changes.

• Use the commit command to save the configuration changes to the running configuration file and remain within the

configuration session.

Enabling Flow-based Load Balancing

Perform this task to enable flow-based load balancing.

L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x

127

Implementing Point to Point Layer 2 Services

Enabling Flow-based Load Balancing

Cisco ASR 9000 Series Configuration Guidelines

Other manuals for Cisco ASR 9000 Series