Cisco ASR 9000 Series

remote-as 100
update-source loopback0
ebgp-multihop 255
address-family ipv4 unicast
address-family l2vpn evpn
send-community extended
route-map passall in
route-map IR-test out
neighbor 192.168.0.6 -------> VXLAN neighbour
remote-as 200
update-source loopback0
address-family l2vpn evpn
send-community both
Verification
Verify that you have configured EVPN VXLAN Ingress Replication feature successfully.
DC3# show evpn evi vpn-id 40 inclusive-multicast detail
Ethernet Tag: 0, Originating IP: 192.168.0.2, vpn-id: 40
Nexthop: 192.168.0.2
Label : 24004
Source : Remote
Encap : MPLS
Ethernet Tag: 0, Originating IP: 192.168.0.3, vpn-id: 40
Nexthop: 192.168.0.3
Label : 24003
Source : Remote
Encap : MPLS
Ethernet Tag: 0, Originating IP: 192.168.0.4, vpn-id: 40
Nexthop: ::
Label : 24001
Source : Local
Encap : MPLS
------------------------------------------------------------------------------------------------------------------------------
DC2# show evpn ethernet-segment interface nve 40 detail
Ethernet Segment Id Interface Nexthops
------------------------ ---------------------------------- --------------------
0028.2828.0000.4000.0013 nv40 128.0.0.1
128.0.0.2
ES to BGP Gates : Ready
ES to L2FIB Gates : Ready
Main port :
Interface name : nve40
Interface MAC : 0000.0000.0000
IfHandle : 0x0003e960
State : Up
Redundancy : Not Defined
ESI type : 0
Value : 28.2828.0000.4000.0013
ES Import RT : 2828.2800.0040 (from ESI)
Source MAC : 0000.0000.0000 (N/A)
Topology :
Operational : MH
Configured : All-active (AApF) (default)
Primary Services : Auto-selection
Secondary Services: Auto-selection
Service Carving Results:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
565
EVPN Features
Verification