Cisco ASR 9000 Series

RP/0/RSP0/CPU0:router (config-l2vpn-pwc)# encapsulation mpls
Sets pseudowire encapsulation to MPLS.
Step 5 protocol ldp
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-pwc-encap-mpls)# protocol ldp
Sets pseudowire signaling protocol to LDP.
Step 6 switching-tlv hide
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-pwc-encap-mpls)# switching-tlv hide
Sets pseudowire TLV to hide.
Step 7 commit
Example:
RP/0/RSP0/CPU0:router (config-l2vpn-pwc-encap-mpls)#commit
Saves configuration changes to the running configuration file and remains in the configuration session.
Enabling Multisegment Pseudowires
Use the pw-status command after you enable the pw-status command. The pw-status command is disabled
by default. Changing the pw-status command reprovisions all pseudowires configured under L2VPN.
SUMMARY STEPS
1. configure
2. l2vpn
3. pw-status
4. commit
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
117
Implementing Point to Point Layer 2 Services
Enabling Multisegment Pseudowires