Cisco ASR 9000 Series

Associating a TE Tunnel with Forward Class Index
The following configuration shows how to associate a TE tunnel with forward-class index:
config
interface tunnel-te1
ipv4 unnumbered Loopback0
autoroute announce
destination 10.10.10.10
forward-class 1
path-option 10 explicit name PATH1
!
Enabling Route Policy for L2VPN VPLS with BGP Autodiscovery
Perform this task to enable route-policy for L2VPN VPLS with BGP autodiscovery configuration. Only
route-policy export is supported.
SUMMARY STEPS
1. configure
2. l2vpn
3. bridge group bridge group name
4. bridge-domain bridge-domain name
5. vfi { vfi-name }
6. autodiscovery bgp
7. route-policy export policy-name
8. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3 bridge group bridge group name
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
275
Implementing Multipoint Layer 2 Services
Associating a TE Tunnel with Forward Class Index