Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interworking ipv4
Configures IPv4 interworking under P2P.
Step 17 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring MLPPP IP Interworking
Perform this tasks to configure cHDLC IP Interworking:
SUMMARY STEPS
1. configure
2. interface typeinterface-path-id
3. multilink [fragment|interleave|ncp]
4. l2transport
5. end
6. l2vpn
7. xconnect group group-name
8. p2p xconnect-name
9. interface typeinterface-path-id
10. interface typeinterface-path-id
11. interworking ipv4
12. interface typeinterface-path-id
13. neighbor{A.B.C.D}{pw-idvalue}
14. pw-classclass-name
15. exit
16. interworking ipv4
17. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
140
Implementing Point to Point Layer 2 Services
Configuring MLPPP IP Interworking
To Next Page
Loading...
Need help?
General
