Cisco ASR 9000 Series

pw-class L2TPV3_V4_CLASS
encapsulation l2tpv3
protocol l2tpv3 class L2TP-CLASS
dfbit set
ipv4 source 25.25.25.25
cookie size 4
!
!
Configuring L2TP Control-Channel Parameters: Example
The following example shows a typical L2TPv3 control-channel configuration:
configure
l2tp-class L2TP-CLASS
authentication
retransmit retries 5
retransmit initial retries 10
retransmit initial timeout max 5
retransmit timeout max 6
hidden
password 7 1511021F07257A767B
hello-interval 10
digest hash MD5
!
Configuration Examples for EVPN-VPWS
Configuring EVPN-VPWS: Example
The following example shows how to configure EVPN-VPWS service.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group pw-he1
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p pw-ss
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface gigabitethernet 0/1/0/9
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor evpn evi 100 target 12 source 10
The following example shows how to configure EVPN-VPWS into PWHE interface.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group xg1
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p pwhe1
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface PW-Ether 1
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor evpn evi 2 target 20 source 20
Configuring an Access PW using EVPN-VPWS: Example
The following example shows how a bridge-domain can configure an access pseudowire using EVPN-VPWS.
RP/0/RSP0/CPU0:router# configure
RP/0/RSP0/CPU0:router(config)# l2vpn
RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group bg1
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bd1
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# neighbor evpn evi 1 target 100
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
199
Implementing Point to Point Layer 2 Services
Configuring L2TP Control-Channel Parameters: Example