Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr-af)# address-family l2vpn mspw
Specifies the L2VPN address family of the neighbor and enters address family configuration mode.
Step 6 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Verifying Single-Segment Pseudowires
To verify the connectivity in SS-PWs, use the ping mpls pseudowire command.
Displaying Information about the L2VPN Single-Segment Pseudowires
The show commands are used to display information about L2VPN Single Segment Pseudowires
• show bgp l2vpn mspw
• show l2vpn pwr summary
• show l2vpn xc
How to Configure EPVN-VPWS
The following steps are performed to configure EVPN-VPWS:
Configuring L2VPN EVPN Address Family Under BGP
Perform this task to configure L2VPN EVPN address family under BGP:
SUMMARY STEPS
1. configure
2. router bgp autonomous-system-number
3. address-family l2vpn evpn
4. neighbor ip-address
5. address-family l2vpn evpn
6. Use the commit or end command.
DETAILED STEPS
Step 1 configure
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
177
Implementing Point to Point Layer 2 Services
Verifying Single-Segment Pseudowires
To Next Page
Loading...
Need help?
General
