Cisco ASR 9000 Series

Configuration on PE3:
interface GigabitEthernet 0/1/0/2.1 l2transport
encapsulation dot1q 200
l2vpn
pbb
backbone-source-mac 00bb.00cc.00dd
bridge group gr1
bridge-domain bd1
interface GigabitEthernet0/1/0/2.1
pbb edge i-sid 300 core-bridge core_b1
bridge group gr2
bridge-domain core_bd1
pbb core
evpn evi 1000
!
router bgp 100
bgp router-id 1.1.1.3
address-family l2vpn evpn
!
neighbor 1.1.1.1
remote-as 100
address-family l2vpn evpn
PBB EVPN on Dual Homed Device/Multi Homed Device with Active/Active
per Flow load-balancing
This examples covers:
• PBB-EVPN service among three PEs in the same AS with a dual homed CE (behind PE1 and PE2) and
a single homed CE (behind PE3)
• PE1/PE2 configured to perform active/active per Flow loadbalancing allowing ingress traffic from the
same I-SID to be handled by both PEs
• Example shows EVI carrying traffic from a single I-SID
• PBB I-SID values must match among PEs connected to a common dual homed site
• ICCP must be configured in PE1, PE2 using a new mode (mode singleton); where no ICCP neighbor is
configured. Note that MLACP parameters such as system MAC/priority must be identical while MLACP
node ID must be unique on PE1/PE2
• ESI must be identical on PEs connected to a common dual homed site. Example shows default behavior
where ESI value is auto-derived from CE's LACP information
• PBB source MAC must be the same on PEs connected to a dual homed site operating on active/active
per flow load-balancing. Example shows default behavior where PBB source MAC value is auto-derived
from CE's LACP information
• CE must be configured with one bundle interface that includes all member interfaces connecting to both
PEs
• BGP RD/RT auto-derived from BGP ASN and EVI ID
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
402
Implementing IEEE 802.1ah Provider Backbone Bridge
PBB EVPN on Dual Homed Device/Multi Homed Device with Active/Active per Flow load-balancing