Cisco ASR 9000 Series

RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi)# multicast p2mp
Configures a point to multipoint pseudowire, and enables the pseudowire in this VFI.
Step 7 signaling protocol bgp
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi-p2mp)# signaling protocol bgp
Enables BGP as the signaling protocol.
Step 8 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Enabling BGP Autodiscover Signaling for P2MP PW on a VFI
Perform this task to enable BGP autodiscovery signaling for P2MP pseudowire on a VFI.
SUMMARY STEPS
1. configure
2. l2vpn
3. bridge group bridge-group-name
4. bridge-domain bridge-domain-name
5. vfi { vfi-name }
6. multicast p2mp
7. signaling protocol bgp
8. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
315
Implementing Multipoint Layer 2 Services
Enabling BGP Autodiscover Signaling for P2MP PW on a VFI