RP/0/RSP0/CPU0:router(config-bgp)# exit
Enables EVPN address family under BGP routing process and enters EVPN address family configuration submode.
Step 7 address-family l2vpn evpn
Example:
RP/0/RSP0/CPU0:router(config-bgp-nbr)# address-family l2vpn evpn
Enables EVPN address family under BGP routing process and enters EVPN address family configuration submode.
Step 8 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuration Examples for Implementing 802.1ah Provider
Backbone Bridge
This section provides these configuration examples:
Configuring Ethernet Flow Points: Example
This example shows how to configure Ethernet flow points:
config
interface GigabitEthernet0/0/0/10.100 l2transport
encapsulation dot1q 100
or
encapsulation dot1ad 100
or
encapsulation dot1ad 100 dot1q 101
Configuring PBB Edge Bridge Domain and Service Instance ID: Example
This example shows how to configure the PBB edge bridge domain:
config
l2vpn
bridge group PBB
bridge-domain PBB-EDGE
interface GigabitEthernet0/0/0/38.100
!
interface GigabitEthernet0/2/0/30.150
!
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
398
Implementing IEEE 802.1ah Provider Backbone Bridge
Configuration Examples for Implementing 802.1ah Provider Backbone Bridge
To Next Page
Loading...
Need help?
General
