Cisco ASR 9000 Series Configuration Guidelines

5. neighbor peer_ip_add
6. address-family l2vpn evpn
7. address-family l2vpn evpn
8. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 router bgp asn_id
Example:
RP/0/RSP0/CPU0:router(config)# router bgp 100
Specifies the BGP AS number and enters the BGP configuration mode, allowing you to configure the BGP routing
process.
Step 3 address-family l2vpn evp
Example:
RP/0/RSP0/CPU0:router(config-bgp)# address-family l2vpn evpn
Enables EVPN address family under BGP routing process and enters EVPN address family configuration submode.
Step 4 exit
Example:
RP/0/RSP0/CPU0:router(config-bgp)# exit
Exits the current configuration mode.
Step 5 neighbor peer_ip_add
Example:
RP/0/RSP0/CPU0:router(config-bgp)# neighbor 10.1.1.1
Places the router in neighbor configuration mode for BGP routing and configures the neighbor IP address as a BGP peer.
Step 6 address-family l2vpn evpn
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
397
Implementing IEEE 802.1ah Provider Backbone Bridge
Configuring BGP Routing Process

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model