Step 8 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configuring MVRP-lite
This section describes the procedure for configuring MVRP-lite:
Enabling MVRP-lite
When MVRP-lite is configured, it is automatically enabled on all interfaces where MSTP is enabled. MSTP
must be configured before MVRP can be enabled. For more information on configuring MSTP, see Configuring
MSTP.
Configuring MVRP-lite parameters
The configurable MVRP-lite parameters are:
• Periodic Transmission
• Join Time
• Leave Time
• Leave-all Time
SUMMARY STEPS
1. configure
2. spanning-tree mst protocol instance identifier
3. mvrp static
4. periodic transmit [ interval seconds ]
5. join-time milliseconds
6. leave-time seconds
7. leaveall-time seconds
8. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
449
Implementing Multiple Spanning Tree Protocol
Configuring MVRP-lite
To Next Page
Loading...
Need help?
General
