RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain abc
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)#
Establishes a bridge domain and enters L2VPN bridge group bridge domain configuration mode.
Step 5 security
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# security
Enables Layer 2 port security on a bridge.
Step 6 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Attaching a Dynamic Host Configuration Protocol Profile
Perform this task to enable DHCP snooping on a bridge and to attach a DHCP snooping profile to a bridge.
SUMMARY STEPS
1. configure
2. l2vpn
3. bridge group bridge-group-name
4. bridge-domain bridge-domain-name
5. dhcp ipv4 snoop { profile profile-name }
6. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
241
Implementing Multipoint Layer 2 Services
Attaching a Dynamic Host Configuration Protocol Profile
To Next Page
Loading...
Need help?
General
