Cisco ASR 9000 Series

RP/0/RSP0/CPU0:router(config-nve-vni)# mcast-group 209.165.202.129
Specifies a multicast address associated with the VNI.
Step 17 host-reachability protocol protocol
Example:
RP/0/RSP0/CPU0:router(config-nve-vni)# host-reachability protocol bgp
Configures the BGP control protocol for VxLAN tunnel endpoint reachability.
Step 18 Use the commit or end command
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
Configure a Bridge Domain
Perform the following steps to configure the bridge domain on the DCI Gateway.
SUMMARY STEPS
1. configure
2. l2vpn
3. bridge group bridge-group-name
4. bridge-domain bridge-domain-name
5. evi ethernet vpn id
6. exit
7. member vni vxlan-id
8. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the global configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
511
EVPN Features
Configure a Bridge Domain