Cisco ASR 9000 Series

Step 8 exit
Example:
RP/0/RSP0/CPU0:router(config-nve-red-backbone-vxlan)# exit
Exits the backbone-vxlan submode and returns to redundancy submode.
Step 9 backbone mpls
Example:
RP/0/RSP0/CPU0:router(config-nve-red)# backbone mpls
Configures ICCP MPLS backbone.
Step 10 iccp group group number
Example:
RP/0/RSP0/CPU0:router(config-nve-red-backbone-mpls)# iccp group 12
Configures ICCP group number for MPLS backbone.
Step 11 exit
Example:
RP/0/RSP0/CPU0:router(config-nve-red-backbone-mpls)# exit
Exits the backbone-mpls submode and returns to redundancy submode.
Step 12 exit
Example:
RP/0/RSP0/CPU0:router(config-nve-red)# exit
Exits the redundancy submode and returns to interface submode.
Step 13 member vni vni_number
Example:
RP/0/RSP0/CPU0:router(config-nve)# member vni 1
Associates a single VxLAN with the NVE interface using the VxLAN Network Identifier (VNI) and specifies a multicast
address associated with this VNI.
Step 14 load-balance per-evi
Example:
RP/0/RSP0/CPU0:router(config-nve-vni)# load-balance per-evi
Configures per-evi load balance mode (default is per-flow).
Step 15 suppress-unknown-unicast-flooding
Example:
RP/0/RSP0/CPU0:router(config-nve-vni)# suppress-unknown-unicast-flooding
Configures the suppression of unknown unicast flooding.
Step 16 mcast-group ip_address
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
510
EVPN Features
Configure Network Virtualization Endpoint (NVE) Interface