RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group bg1
Enters configuration mode for the named bridge group.
Step 4 bridge-domain bridge-domain name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain bd1
Enters configuration mode for the named bridge domain.
Step 5 vfi { vfi-name }
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# vfi vfi-east
Enters virtual forwarding instance (VFI) configuration mode.
Step 6 autodiscovery bgp
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi)# autodiscovery bgp
Enters BGP autodiscovery configuration mode where all BGP autodiscovery parameters are configured.
This command is not provisioned to BGP until at least the VPN ID and the signaling protocol is configured.
Step 7 route-policy export policy-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi-ad)# route-policy export RPL_1
Attaches the route-policy at route-policy export attach point.
Step 8 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
276
Implementing Multipoint Layer 2 Services
Enabling Route Policy for L2VPN VPLS with BGP Autodiscovery
To Next Page
Loading...
Need help?
General
