Example:
RP/0/RSP0/CPU0:router(config-l2vpn-pwc-mpls)# load-balancing flow-label both
Enables load-balancing on ECMPs. Also, enables the imposition and disposition of flow labels for the pseudowire.
If the static keyword is not specified, end to end negotiation of the FAT PW is enabled.
Note
Step 6 exit
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-pwc-mpls)#exit
RP/0/RSP0/CPU0:router(config-l2vpn-pwc)#
Exits the pseudowire encapsulation submode and returns the router to the parent configuration mode.
Step 7 exit
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-pwc)#exit
RP/0/RSP0/CPU0:router(config-l2vpn)#
Exits the pseudowire submode and returns the router to the l2vpn configuration mode.
Step 8 xconnect group group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group grp1
RP/0/RSP0/CPU0:router(config-l2vpn-xc)#
Specifies the name of the cross-connect group.
Step 9 p2p xconnect-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p vlan1
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)#
Specifies the name of the point-to-point cross-connect.
Step 10 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface TenGigE 0/0/0/0.1
Specifies the interface type and instance.
Step 11 neighbor A.B.C.D pw-id pseudowire-id
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
288
Implementing Multipoint Layer 2 Services
Enabling Load Balancing with ECMP and FAT PW for VPWS
To Next Page
Loading...
Need help?
General
