Cisco ASR 9000 Series

RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config-subif)# l2vpn
Enters L2VPN configuration mode.
Step 3 xconnect group group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group grp_1
Enters the name of the cross-connect group.
Step 4 p2p xconnect-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p vlan1
Enters a name for the point-to-point cross-connect.
Step 5 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface TenGigE 0/7/0/6.5
Specifies the interface type ID. The choices are:
• GigabitEthernet: Gigabit Ethernet/IEEE 802.3 interfaces
• TenGigE: TenGigabit Ethernet/IEEE 802.3 interfaces
• CEM: Circuit Emulation interface
Step 6 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface GigabitEthernet0/4/0/30
Specifies the interface type ID. The choices are:
• GigabitEthernet: Gigabit Ethernet/IEEE 802.3 interfaces
• TenGigE: TenGigabit Ethernet/IEEE 802.3 interfaces
Step 7 Use the commit or end command.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
102
Implementing Point to Point Layer 2 Services
Configuring Local Switching