Name: Cisco ASR 9000 Series
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Specifies the interface type and instance.

Step 11 interworking ipv4

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interworking ipv4

Configures IPv4 interworking under P2P.

Step 12 interface typeinterface-path-id

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface Serial0/0/0/0/2/1/1:0

Specifies the interface type and instance.

Step 13 neighbor{A.B.C.D}{pw-idvalue}

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor 120.120.120.120 pw-id 3

Configures the pseudowire segment for the cross-connect.

Use the A.B.C.D argument to specify the IP address of the cross-connect peer.

A.B.C.D can be a recursive or non-recursive prefix

Note

Optionally, you can disable the control word or set the transport-type to Ethernet or VLAN

Step 14 pw-classclass-name

Example:

RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p-pw)# pw-class class_cem

Enters pseudowire class submode, allowing you to define a pseudowire class template.

Step 15 exit

Example:

RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p-pw)# exit

Exits the current configuration mode.

Step 16 interworking ipv4

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interworking ipv4

Configures IPv4 interworking under P2P.

Step 17 Use the commit or end command.

commit - Saves the configuration changes and remains within the configuration session.

end - Prompts user to take one of these actions:

• Yes - Saves configuration changes and exits the configuration session.

• No - Exits the configuration session without committing the configuration changes.

• Cancel - Remains in the configuration mode, without committing the configuration changes.

L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x

142

Implementing Point to Point Layer 2 Services

Configuring MLPPP IP Interworking

Cisco ASR 9000 Series Configuration Guidelines

Other manuals for Cisco ASR 9000 Series