Cisco ASR 9000 Series

DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router (config)# l2vpn
Enters Layer 2 VPN configuration mode.
Step 3 xconnect group group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group grp_1
Configures a cross-connect group and specifies it’s name.
Step 4 p2p xconnect-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p vlan1
Configures a point-to-point cross-connect.
Step 5 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface GigabitEthernet0/4/0/30
Specifies the interface type ID. The choices are:
• GigabitEthernet: Gigabit Ethernet/IEEE 802.3 interfaces
• TenGigE: TenGigabit Ethernet/IEEE 802.3 interfaces
Step 6 neighbor ipv6 X:X::X pw-idpseudowire-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor ipv6 1111:2222::cdef pw-id 2000
Specifies the peer with which to cross connect, and configures the pseudowire segment for the cross-connect.
Step 7 Use the commit or end command.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
152
Implementing Point to Point Layer 2 Services
Configuring Neighbor AFI for Pseudowire