Name: Cisco ASR 9000 Series
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

DETAILED STEPS

Step 1 configure

Example:

RP/0/RSP0/CPU0:router# configure

Enters global configuration mode.

Step 2 l2vpn

Example:

RP/0/RSP0/CPU0:router (config)# l2vpn

Enters Layer 2 VPN configuration mode.

Step 3 xconnect group group-name

Example:

RP/0/RSP0/CPU0:router (config-l2vpn)# xconnect group g1

Configures the cross-connect group.

Step 4 p2p xconnect-name

Example:

RP/0/RSP0/CPU0:router (config-l2vpn-xc)# p2p xc3

Configures the point-to-point cross-connect.

Step 5 interface type interface-path-id

Example:

RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p)# interface GigabitEthernet0/0/0/4.2

Specifies the interface type ID.

Step 6 neighbor ipv6 peer-address pw-id pseudowire-id

Example:

RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p)# neighbor ipv6 1111:2222::cdef pw-id 1

Specifies the peer with which to cross connect, and configures the pseudowire segment for the cross-connect.

Step 7 source pw-source-address

Example:

RP/0/RSP0/CPU0:router (config-l2vpn-xc-p2p-pw)# source 1111:2222::abcd

Configures the source IPv6 address of the pseudowire.

The source IPv6 address must be unique and chosen arbitrarily. It should not be configured on any type of

interfaces in the router.

Note

Step 8 end or commit

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p-pw)# end

L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x

155

Implementing Point to Point Layer 2 Services

Configuring Source IPv6 address for L2TPv3 over IPv6 tunnel

Cisco ASR 9000 Series Configuration Guidelines

Other manuals for Cisco ASR 9000 Series