Cisco ASR 9000 Series Configuration Guidelines

DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters Layer 2 VPN configuration mode.
Step 3 router-id router-id
Example:
RP/0/RSP0/CPU0:router(config)# router 2.2.2.2
Specifies the router ID.
Step 4 pw-routing
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# pw-routing
Enables pseudowire routing capabilities and enters the pseudowire routing configuration submode
Step 5 global-id global-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-pwr)# global-id 1000
Configures the L2VPN global ID value for the router.
Step 6 bgp
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-pwr)# bgp
Enables the BGP pseudowire routing capabilities and enters the BGP configuration submode.
Step 7 rd route-distinguisher
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
173
Implementing Point to Point Layer 2 Services
Configuring L2VPN Global Parameters

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model