Software and Hardware Support 491
Configure EVPN Native with Software MAC Learning 491
Supported Modes for EVPN Native with Software MAC Learning 492
Single Home Device or Single Home Network 492
Configure EVPN in Single Home Device or Single Home Network 492
Dual Home Device—All-Active Load Balancing Mode 493
Configure EVPN Software MAC Learning in Dual Home Device—All-Active Mode 494
Dual Home Device—Single-Active Load Balancing 496
Configure EVPN in Dual Home Device—Single-Active Mode 496
Verify EVPN Native with Software MAC Learning 498
EVPN VXLAN Layer 2 Data Center Interconnect Gateway 500
All-Active Multi Homing with Anycast VTEP IP Address 500
All-Active Multi Homing with Unique VTEP IP Address 501
EVPN ESI Multipath for VxLAN - EVI Based Load balancing 501
EVPN ESI Multipath for VxLAN - Flow-based Load Balancing 502
Configure EVPN VXLAN Layer 2 Data Center Interconnect Gateway 503
Configure L2 EVPN Address Family under BGP Routing Process 503
Configure the Routing Sessions Between the DCI and ToR 504
Configure BGP session for remote DCI Connectivity 506
Configure Network Virtualization Endpoint (NVE) Interface 508
Configure a Bridge Domain 511
Configure BGP Route Targets Import/Export Rules 512
Configure Ethernet Segment Identifier 514
Configure ICCP Group 516
Enable Flow-based Load Balancing 517
Example: All-Active Multi Homing with Anycast VTEP IP Address Configuration 518
Example: All-Active Multi Homing with Unique VTEP IP Address Configuration 519
EVPN MPLS Seamless Integration with VPLS 520
Migrate VPLS Network to EVPN Network through Seamless Integration 520
Configure EVPN on the Existing VPLS Network 521
EVPN Single-Active Multi-Homing 532
Configure EVPN Single-Active Multi-Homing 533
Configuring EVPN Ethernet Segment 533
Configure EVPN Service Instance (EVI) Parameters 536
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
xx
Contents
To Next Page
Loading...
Need help?
General
