Cisco ASR 9000 Series Configuration Guidelines

You can configure the PWHE interface as well, using EVPN-VPWS. Refer to the Configuring Pseudowire
Headend, on page 292 module for more information.
Note
SUMMARY STEPS
1. configure
2. interface type interface-path-id
3. l2vpn
4. xconnect group group-name
5. p2p xconnect-name
6. interface type interface-path-id
7. neighbor evpn evi vpn-idtarget ac-id
8. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config)# interface TenGigE0/1/0/12
Enters interface configuration mode and configures an interface.
Step 3 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters Layer 2 VPN configuration mode.
Step 4 xconnect group group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group xc1
Configures a cross-connect group name using a free-format 32-character string.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
179
Implementing Point to Point Layer 2 Services
Configuring EVPN-VPWS

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model