Name: Cisco ASR 9000 Series
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

RP/0/RSP0/CPU0:router(config-l2vpn-bg)#

Creates a bridge group so that it can contain bridge domains and then assigns network interfaces to the bridge domain.

Step 4 bridge-domain bridge-domain name

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain abc

RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)#

Establishes a bridge domain and enters L2VPN bridge group bridge domain configuration mode.

Step 5 (Optional) interface type interface_id

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# interface gigabitEthernet 0/2/0/1

RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-ac)#

Enters the interface configuration mode of the specified interface and adds this interface as the bridge domain member

interface.

Run this step if you want to configure the MAC address limit only for a specific interface. The further steps

show the router prompt displayed when you have skipped this step to configure the MAC address limit at

the bridge domain level.

Note

Step 6 mac

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# mac

RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-mac)#

Enters L2VPN bridge group bridge domain MAC configuration mode.

Step 7 limit

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-mac)# limit

RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-mac-limit)#

Sets the MAC address limit for action, maximum, and notification and enters L2VPN bridge group bridge domain

MAC limit configuration mode.

Step 8 maximum { value }

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-mac-limit)# maximum 5000

Configures the specified action when the number of MAC addresses learned on a bridge is reached.

Step 9 action { flood | no-flood | shutdown }

L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x

257

Implementing Multipoint Layer 2 Services

Configuring the MAC Address Limit

Cisco ASR 9000 Series Configuration Guidelines

Other manuals for Cisco ASR 9000 Series