Name: Cisco ASR 9000 Series
Brand: Cisco
Rating: 4 (1 reviews)

To Next Page

To Previous Page

Step 2 l2vpn

Example:

RP/0/RSP0/CPU0:router(config)# l2vpn

Enters L2VPN configuration mode.

Step 3 bridge group bridge group name

Example:

RP/0/RSP0/CPU0:router(config-l2vpn)# bridge group metroA

Enters configuration mode for the named bridge group.

Step 4 bridge-domain bridge-domain name

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-bg)# bridge-domain east

Enters configuration mode for the named bridge domain.

Step 5 vfi { vfi-name }

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# vfi vfi-east

Enters virtual forwarding instance (VFI) configuration mode.

Step 6 vpn-id vpn-id

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi)# vpn-id 100

Specifies the identifier for the VPLS service. The VPN ID has to be globally unique within a PE router. i.e., the same

VPN ID cannot exist in multiple VFIs on the same PE router. In addition, a VFI can have only one VPN ID.

Step 7 autodiscovery bgp

Example:

RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-vfi)# autodiscovery bgp

Enters BGP autodiscovery configuration mode where all BGP autodiscovery parameters are configured.

This command is not provisioned to BGP until at least the VPN ID and the signaling protocol is configured.

Step 8 rd { as-number:nn | ip-address:nn | auto }

Example:

L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x

268

Implementing Multipoint Layer 2 Services

Configuring VPLS with BGP Autodiscovery and Signaling

Cisco ASR 9000 Series Configuration Guidelines

Other manuals for Cisco ASR 9000 Series