Cisco ASR 9000 Series

RP/0/RSP0/CPU0:router(config)# l2vpn
Enters Layer 2 VPN configuration mode.
Step 3 xconnect group group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group pw-he1
Configures a cross-connect group name using a free-format 32-character string.
Step 4 p2p xconnect-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p pw-hexconnect
Enters P2P configuration submode.
Step 5 interface pw-ether id or interface pw-iw id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface pw-ether 100
or
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p )# interface pw-iw 100
Configures the PWHE interface.
Step 6 neighbor ip-address pw-id value
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor 10.165.200.25 pw-id 100
Configures a pseudowire for a cross-connect.
The IP address is that of the corresponding PE node.
The pw-id must match the pw-id of the PE node.
Step 7 pw-class class-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p-pw)# pw-class dynamic_mpls
Enters pseudowire class submode, allowing you to define a pseudowire class template.
The pseudowire class should be defined under l2vpn for VC4 and VC5 as follows:
Note
pw-class vc_type_4
encapsulation mpls
transport-mode vlan
!
!
pw-class vc_type_5
encapsulation mpls
transport-mode ethernet
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
296
Implementing Multipoint Layer 2 Services
Configuring PWHE Crossconnect