Cisco ASR 9000 Series

7. dampening decay-life
8. logging events link-status
9. (Only PW-Ether main interfaces) mac-address MAC address
10. mtu interface_MTU
11. bandwidth kbps
12. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 interface pw-ether id (or) interface pw-iw id
Example:
RP/0/RSP0/CPU0:router(config)# interface pw-ether <id>
or
RP/0/RSP0/CPU0:router(config)# interface pw-iw <id>
(interface pw-ether id) Configures the PWHE interface and enters the interface configuration mode.
(interface pw-iw id) Configures the PWHE interface and enters the interface configuration mode.
Step 3 ipv4 address ip-address subnet-mask (or) (Only PW-Ether) ipv6 address ipv6-prefix/prefix-length
Example:
RP/0/RSP0/CPU0:router(config-if)# ipv4 address 40.1.1.2 255.255.255.0
Sets the IPv4 or IPv6 address of the interface.
Step 4 attach generic-interface-list interface_list_name
Example:
RP/0/RSP0/CPU0:router(config-if)# attach generic-interface-list interfacelist1
Attaches the generic interface list to the PW-Ether or PW-IW interface.
Step 5 l2overhead bytes
Example:
RP/0/RSP0/CPU0:router(config-if)# l2overhead 20
Sets layer 2 overhead size.
Step 6 load-interval seconds
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
299
Implementing Multipoint Layer 2 Services
Configuring PWHE Interface Parameters