Cisco ASR 9000 Series

RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-ac)#end
RP/0/RSP0/CPU0:Jul 26 10:48:21.342 EDT: config[65751]: %MGBL-SYS-5-CONFIG_I : Configured
from console by lab
RP/0/RSP0/CPU0:router#show bundle Bundle-ether10
Bundle-Ether10
Status: Down
Local links <active/standby/configured>: 0 / 0 / 2
Local bandwidth <effective/available>: 0 (0) kbps
MAC address (source): 0024.f71e.22eb (Chassis pool)
Minimum active links / bandwidth: 1 / 1 kbps
Maximum active links: 64
Wait while timer: 2000 ms
LACP: Operational
Flap suppression timer: Off
mLACP: Not configured
IPv4 BFD: Not configured
Port Device State Port ID B/W, kbps
-------------------- --------------- ----------- -------------- ----------
Gi0/2/0/5 Local Configured 0x8000, 0x0001 1000000
Link is down
Gi0/2/0/6 Local Configured 0x8000, 0x0002 1000000
Link is down
RP/0/RSP0/CPU0:router#
RP/0/RSP0/CPU0:router#show l2vpn bridge-domain group examples
Bridge group: examples, bridge-domain: test-switch, id: 2000, state: up, ShgId: 0, MSTi: 0
Aging: 300 s, MAC limit: 4000, Action: none, Notification: syslog
Filter MAC addresses: 0
ACs: 4 (1 up), VFIs: 0, PWs: 0 (0 up), PBBs: 0 (0 up)
List of ACs:
BE10, state: down, Static MAC addresses: 0
Gi0/2/0/0, state: up, Static MAC addresses: 0
Gi0/2/0/1, state: down, Static MAC addresses: 0
Te0/5/0/1, state: down, Static MAC addresses: 0
List of VFIs:
RP/0/RSP0/CPU0:router#
This table lists the configuration steps (actions) and the corresponding purpose for this example:
SUMMARY STEPS
1. configure
2. interface Bundle-ether10
3. l2transport
4. interface GigabitEthernet0/2/0/5
5. bundle id 10 mode active
6. interface GigabitEthernet0/2/0/6
7. bundle id 10 mode active
8. interface GigabitEthernet0/2/0/0
9. l2transport
10. interface GigabitEthernet0/2/0/1
11. l2transport
12. interface TenGigE0/1/0/2
13. l2transport
14. l2vpn
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
328
Implementing Multipoint Layer 2 Services
Bridging on IOS XR Trunk Interfaces: Example