Cisco ASR 9000 Series

Step 12 interface TenGigE0/1/0/2
Enters interface configuration mode. Changes configuration mode to act on TenGigE0/1/0/2.
Step 13 l2transport
Changes TenGigE0/1/0/2 from an L3 interface to an L2 interface.
Step 14 l2vpn
Enters L2VPN configuration mode.
Step 15 bridge group examples
Creates the bridge group examples.
Step 16 bridge-domain test-switch
Creates the bridge domain test-switch, that is a member of bridge group examples.
Step 17 interface Bundle-ether10
Establishes Bundle-ether10 as an AC of bridge domain test-switch.
Step 18 exit
Exits bridge domain AC configuration submode, allowing next AC to be configured.
Step 19 interface GigabitEthernet0/2/0/0
Establishes GigabitEthernet0/2/0/0 as an AC of bridge domain test-switch.
Step 20 exit
Exits bridge domain AC configuration submode, allowing next AC to be configured.
Step 21 interface GigabitEthernet0/2/0/1
Establishes GigabitEthernet0/2/0/1 as an AC of bridge domain test-switch.
Step 22 exit
Exits bridge domain AC configuration submode, allowing next AC to be configured.
Step 23 interface TenGigE0/1/0/2
Establishes interface TenGigE0/1/0/2 as an AC of bridge domain test-switch.
Step 24 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
end - Prompts user to take one of these actions:
• Yes - Saves configuration changes and exits the configuration session.
• No - Exits the configuration session without committing the configuration changes.
• Cancel - Remains in the configuration mode, without committing the configuration changes.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
330
Implementing Multipoint Layer 2 Services
Bridging on IOS XR Trunk Interfaces: Example