Cisco ASR 9000 Series Configuration Guidelines

6. interface type interface-path-id.subinterface
7. pbb edge i-sid service-id core-bridge core-bridge-name
8. static-mac-address cda-mac-address bmac bda-mac-address
9. Use the commit or end command.
DETAILED STEPS
Step 1 configure
Example:
RP/0/RSP0/CPU0:router# configure
Enters the Global Configuration mode.
Step 2 l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3 bridge group bridge-group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)#bridge group pbb
Enters configuration mode for the named bridge group. This command creates a new bridge group or modifies the existing
bridge group if it already exists. A bridge group organizes bridge domains.
Step 4 bridge-domain domain-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg)#bridge-domain pbb-edge
Enters configuration mode for the named bridge domain. This command creates a new bridge domain or modifies the
existing bridge domain if it already exists.
Step 5 interface type interface-path-id.subinterface
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)#interface GigabitEthernet0/5/0/0.20
Assigns the matching VLAN ID and Ethertype to the interface.
Step 6 interface type interface-path-id.subinterface
Example:
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
381
Implementing IEEE 802.1ah Provider Backbone Bridge
Configuring Static MAC addresses under PBB Edge Bridge Domain

Cisco ASR 9000 Series Specifications

General

Series	ASR 9000
Category	Network Router
Modular Design	Yes
Redundancy	Yes (Hardware and Software)
Operating System	Cisco IOS XR
Interfaces/Ports	10G, 40G, 100G, 400G Ethernet
Expansion Slots	Varies by model
Routing Protocol	BGP, OSPF, IS-IS, EIGRP
Management	CLI, SNMP, NETCONF
Power Supply	Redundant
Port Density	Varies by model
Power Supply Options	AC, DC
Memory	Varies by model
Storage	Varies by model
Dimensions	Varies by model
Weight	Varies by model