Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-mac)# exit
Exits the current configuration mode.
Step 7 interface type interface-path-id.subinterface
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# interface GigabitEthernet0/5/0/0.20
Assigns the matching VLAN ID and Ethertype to the interface.
Step 8 interface type interface-path-id.subinterface
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-ac)# interface GigabitEthernet0/5/0/1.15
Adds an interface to a bridge domain that allows packets to be forwarded and received from other interfaces that are
part of the same bridge domain. The interface now becomes an attachment circuit on this bridge domain.
Step 9 neighbor { A.B.C.D } pw-id value
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# neighbor 10.1.1.2 pw-id 1000
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-pw)#
Adds an access pseudowire port to a bridge domain.
• Use the A.B.C.D argument to specify the IP address of the cross-connect peer.
A.B.C.D can be a recursive or non-recursive prefix.
Note
• Use the pw-id keyword to configure the pseudowire ID and ID value. The range is 1 to 4294967295.
Step 10 exit
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd-pw)# exit
Exits the current configuration mode.
Step 11 pbb edge i-sid service-id core-bridge core-bridge-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-bg-bd)# pbb edge i-sid 1000 core-bridge pbb-core
Configures the bridge domain as PBB edge with the service identifier and the assigned core bridge domain and enters
the PBB edge configuration submode.
All the interfaces (bridge ports) under this bridge domain are treated as the customer network ports (CNP).
Step 12 Use the commit or end command.
commit - Saves the configuration changes and remains within the configuration session.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
384
Implementing IEEE 802.1ah Provider Backbone Bridge
Configuring Access Pseudowire in I-Component
To Next Page
Loading...
Need help?
General
