Step 13 instance id
Example:
RP/0/RSP0/CPU0:router(config-mstag-if)# instance 1
Enters the MSTI configuration submode.
Allowed values for the MSTI ID are from 0 through 4094.
Step 14 edge mode
Example:
RP/0/RSP0/CPU0:router(config-mstag-if-inst)# edge mode
Enables access gateway edge mode for this MSTI.
Step 15 vlan-id vlan-range [, vlan-range ] [,vlan-range ] [,vlan-range ]
Example:
RP/0/RSP0/CPU0:router(config-mstag-if-inst)# vlan-id 2-1005
Associates a set of VLAN IDs with the current MSTI.
List of VLAN ranges in the form a-b, c, d, e-f, g, and so on.
Step 16 priority priority
Example:
RP/0/RSP0/CPU0:router(config-mstag-if-inst)# priority 4096
Sets the bridge priority for the current MSTI.
Allowed values are from 0 through 61440 in multiples of 4096.
Step 17 port-priority priority
Example:
RP/0/RSP0/CPU0:router(config-mstag-if-inst)# port-priority 160
Sets the port priority performance parameter for the MSTI.
Allowed values for port priority are from 0 through 240 in multiples of 16.
Step 18 cost cost
Example:
RP/0/RSP0/CPU0:router(config-mstag-if-inst)# cost 10000
Sets the internal path cost for a given instance on the current port.
Allowed values for port cost are from 1 through 200000000.
L2VPN and Ethernet Services Configuration Guide for Cisco ASR 9000 Series Routers, IOS XR Release 6.3.x
437
Implementing Multiple Spanning Tree Protocol
Configuring MSTAG parameters
To Next Page
Loading...
Need help?
General
