Cisco D9854 Installation And Configuration Guide

Setup Menu
105
Menu Item
Description
Parameters
Service ID
Displays the service available in
SDI.
EIA-708, AFD, DPI, SMPTE-
2031, Multi-OP47, and SDP-
OP47
Enabled
Select whether the selected service
is enabled or disabled in the SDI
output.
Note: If services are not present,
they will not be sent to the output.
Yes or No
Line Offset
Set the offset number from the
Switch line parameter displayed in
the SDI - Global menu. For more
information, see SDI - Global (on
page 57).
Note: The SMPTE standard
recommends two as the minimum
supported line offset.
Audio Slot
Menu Item
Description
Parameters
Group, Slot <-
Audio Ch
This selects the audio channel
grouping, and audio channels from
the available audio group.
Group: This the channel group
- 1 to 4.
Slot: This is the HANC
position - 1 to 4.
Audio: This is the audio source
- 1, 2.
Ch: This is the source audio
channel - left, right.
Subtitles
This menu allows you to configure the type of subtitling (for example, DVB or Imitext)
displayed by the receiver, and how the receiver displays subtitling on the TV.

Cisco D9854 Specifications

General

Model	D9854
Category	Receiver
Output	ASI, IP
Decoding	MPEG-2
Conditional Access	BISS
Receiver Type	Professional IRD
解密	DVB-CSA, BISS, AES
Input Frequency Range	950 MHz to 2150 MHz
Modulation Formats	QPSK, 8PSK
Symbol Rate	1 to 45 Msps
Power Supply	100-240 VAC, 50/60 Hz
Power Consumption	40W (typical)
Operating Temperature	0°C