Chapter 4 Front Panel Operation
10 Press MENU three times to exit the TS Out menu and save the data. If the
changes cannot be saved/made, a message will be displayed indicating "Bad
configuration data". The following options are available: Abandon, Exit or
Return. Select Return to re-enter the parameter.
Note: When remapping an input program channel to an output channel, ensure
that the PIDs are mapped to different PIDs to avoid PID collisions.
Sy nchronizing Output Serv ices
Note: The resynchronization will not synchronize the inputs if there is no valid input
on the PE or if the PE is set to channel 0.
To synchronize the output to the input Services Only:
This operation synchronizes the inputs to the outputs according to the service
assignments only. This is useful when you already have PID assignments set for the
services but want to ensure that the services are mapped correctly.
1 On the DPM menu, map the output services as desired.
2 Select PE Resync: Svcs. The receiver will synchronize the PE output according to
the available input services only, and ignore the input to output service PID
mapping.
To synchronize the output to the input PIDs only:
This operation synchronizes the inputs to the outputs according to the PID
assignments only. This is useful when you have already have the services set up but
want to synchronize to the incoming PIDs.
1 On the DPM menu, map the output services as desired.
2 Select PE Resync: PIDs. The receiver will synchronize the PE output according to
the input PIDs only, and ignore the service assignment categories/names.
To synchronize the output to All (Services and PIDs):
This operation synchronizes the inputs to the outputs of the current PMT according
to the service assignments and then the PID assignments. This is similar to a sample
and hold function.
1 On the Detailed Program Mapping Active menu, map the outputs services as
desired.
2 Select PE Resync: All. The receiver will synchronize the PE output according to
the services and then the PIDs assigned to each service.
To synchronize the output to a Template:
Using a template allows you to preset the input to output mapping of a PE according
to the preset template. This is helpful in pre-configuring any number of PEs for
future use.
To Next Page
Loading...
Need help?
General
