5-23
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 5 Setup and Monitoring via Web GUI
Configuring the Common Interface (CI) Information
Step 2 From the Decryption Mode drop-down list, choose whether to decrypt the program on the selected
CAM (Yes, No, Comp). Select Comp to customize the PID or stream type to decrypt.
Step 3 Choose Enable from the CI CAM QUERY Support drop-down list to query the CAM prior to
decryption to ensure that the card can be decrypted. The default is Disable.
Step 4 Choose Enable from the CI CAM Auto Reset drop-down list to automatically reset the card. The default
is Disable.
Step 5 From the CA List Management Type drop-down list, choose AddDel (Default) to add or delete
programs individually in the CAM. Set to Update All to automatically update and reset all the programs
each time you add or modify the programs available via the CAM.
Step 6 Choose Enable from the TS/ONID Check drop-down list if you want to restrict the incoming transport
stream to the transport ID and transport original network ID listed below. If the incoming stream does
not match the specified transport stream, the CAM will not decrypt. The default is Disable.
Step 7 In the Transport ID and Original Network ID fields, enter the transport ID and network ID if
TS/ONID Check is set to Enable. If the incoming stream does not match the specified IDs here, the
CAM will not decrypt. You can enter a value in the range from 0 to 65535.
Step 8 If you chose Comp as the Decryption Mode, you can insert and maintain customized records in the CI
Component Setup section. Each record customizes the PID or stream type to decrypt. The Index number
is a read only field that indicates the record number. You can maintain up to 32 records.
To insert a new record, click Add. A new row appears at the top of the table (see below).
There are various configurations when creating a new record. The following table summarizes the
various methods:
If you set by Parameter Settings
PID Set Mode to PID and enter PID number.
To Next Page
Loading...
Need help?
General
