Contents
v
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Adding a Favorite Profile 4-10
Editing a Favorite Profile 4-11
Deleting a Favorite Profile 4-12
Performing a Channel Scan 4-12
Setting Up One Button Channel Change 4-12
Setup Menu 4-14
Setting up Tuning / Preset 4-15
Setting up the Preset / LNB 4-17
Selecting the Active Preset 4-18
Editing Network Presets 4-19
Setting up LNB 4-19
Setting Up the Satellite Dish 4-21
Adjusting the Satellite Position in Installer Mode 4-25
Changing the Satellite Position in User Mode 4-25
Adjusting the Satellite position using Signal Tones 4-25
Signal Level and Signal Quality 4-26
Signal Lock 4-26
Setting up the Video 4-26
Actual Conversion Table 4-28
Video Output Restrictions 4-31
Setting up Subtitles 4-32
Setting up Audio 4-33
Digital Audio Preference Settings 4-34
Viewing Advanced Settings 4-35
Setting up Advanced User Settings 4-36
Changing the Lock Level 4-38
Performing a Factory Reset 4-39
Rebooting the Receiver 4-39
Resetting the Web GUI Login Information 4-40
Setting up POV Mode 4-40
Viewing the Network Setup Menu (D9865D only) 4-41
Configuring IP Setup 4-42
Setting the Unicast IP Address 4-45
Setting the Multicast IP Address 4-47
Setting up SNMP 4-48
Configuring Noise Cutoffs 4-50
Setting up Alarms and Warnings 4-53
Performing Over-the-Air Downloads 4-55
Setting Bootable Application Selection 4-56
Viewing System Information 4-57