Cisco D9865 Installation And Configuration Guide

4-43
Cisco D9865 Satellite Receiver Software Version 2.20 Installation and Configuration Guide
OL-31085-01
Chapter 4 Setup and Monitoring via On-Screen Display
Setup Menu
Setting the Filter Mode
The filter mode sets the multicast forwarding for MPE data output.
Proceed as follows to set up the filter mode:
Step 1 From the Advanced Setup screen, select IP Setup and press OK.
Step 2 The Filter Mode sets whether all the MPE data is forwarded (Forward All). It can forward up to 5 PIDs
at the maximum bit rates shown in the following table. Otherwise, select Forward None.
Step 3 Set the MPE Optimization setting. Select High Bitrate (default) to accumulate the IP packets before
they are processed in short bursts, increasing the allowable bit rate of MPE data. Select Low Jitter to
emit the IP packets in a constant stream, resulting in low latency.
MPE Bit Rate No Decoding
5 Mbps SD Video
Decoded
20 Mbps HD Video
Decoded
Multicast 30 Mbps 20 Mbps 15 Mbps
Unicast 20 Mbps 15 Mbps 10 Mbps

Cisco D9865 Specifications

General

Brand	Cisco
Model	D9865
Category	Receiver
Language	English