2-93
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter 2 Cisco ME 3800X and ME 3600X Switch Cisco IOS Commands
interface range
• gigabitethernet module/{first port} - {last port}, where module is always 0
• tengigabitethernet module/{first port} - {last port}, where module is always 0
For physical interfaces:
–
module is always 0
–
the range is type 0/number - number (for example, gigabitethernet0/1 - 2)
• port-channel port-channel-number - port-channel-number, where port-channel-number is from 1
to 48
Note When you use the interface range command with port channels, the first and last port channel number
in the range must be active port channels.
When you define a range, you must enter a space between the first entry and the hyphen (-):
interface range gigabitethernet0/1 -2
When you define multiple ranges, you must still enter a space after the first entry and before the
comma (,):
interface range tengigabitetherne0/1 - 2, gigabitethernet0/1 - 2
You cannot specify both a macro and an interface range in the same command.
A single interface can also be specified in port-range (this would make the command similar to the
interface interface-id global configuration command).
Note For more information about configuring interface ranges, see the software configuration guide for this
release.
Examples This example shows how to use the interface range command to enter interface range configuration
mode to apply commands to two ports:
Switch(config)# interface range gigabitethernet0/1 - 2
Switch(config-if-range)#
This example shows how to use a port-range macro macro1 for the same function. The advantage is that
you can reuse macro1 until you delete it.
Switch(config)# define interface-range macro1 gigabitethernet0/1 - 2
Switch(config)# interface range macro macro1
Switch(config-if-range)#
Related Commands Command Description
define interface-range Creates an interface range macro.
show running-config Displays the operating configuration.
To Next Page
Loading...
Need help?
General