Cisco ME 3600X User Manual

-6
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter
snmp-server enable traps
Note Though visible in the command-line help strings, the dot1x, energywise, event-manager, fru-ctrl
insertion and removal, and vtp keywords are not supported. The snmp-server enable informs global
configuration command is not supported. To enable the sending of SNMP inform notifications, use the
snmp-server enable traps global configuration command combined with the snmp-server host
host-addr informs global configuration command.
Defaults The sending of SNMP traps is disabled.
pim
[invalid-pim-message |
neighbor-change |
rp-mapping-change]
(Optional) Enables Protocol-Independent Multicast (PIM) traps. The
keywords have these meanings:
• invalid-pim-message—(Optional) Enables invalid PIM message traps.
• neighbor-change—(Optional) Enables PIM neighbor-change traps.
• rp-mapping-change—(Optional) Enables rendezvous point
(RP)-mapping change traps.
rtr (Optional) Enables SNMP Response Time Reporter traps.
snmp [authentication |
coldstart | linkdown |
linkup | warmstart]
(Optional) Enables SNMP traps. The keywords have these meanings:
• authentication—(Optional) Enables authentication trap.
• coldstart—(Optional) Enables cold-start trap.
• linkdown—(Optional) Enables linkdown trap.
• linkup—(Optional) Enables linkup trap.
• warmstart—(Optional) Enables warm-start trap.
storm-control
trap-rate value
(Optional) Enables storm-control traps. Use the trap-rate keyword to set the
maximum number of storm-control traps sent per minute. The range is from
0 to 1000; the default is 0 (no limit is imposed; a trap is sent at every
storm-control occurrence).
stpx [inconsistency]
[root-inconsistency]
[loop-inconsistency]
(Optional) Enables SNMP STPX MIB traps. The keywords have these
meanings:
• inconsistency—(Optional) Enables SNMP STPX MIB inconsistency
update traps.
• root-inconsistency—(Optional) Enables SNMP STPX MIB root
inconsistency update traps.
• loop-inconsistency—(Optional) Enables SNMP STPX MIB loop
inconsistency update traps.
syslog (Optional) Enables SNMP syslog traps.
transceiver all (Optional) Enables SNMP traps for all supported Digital Optical Monitoring
(DoM)-capable transceivers installed on the switch.
tty (Optional) Sends TCP connection traps. This is enabled by default.
vlan-membership (Optional) Enables SNMP VLAN membership traps.
vlancreate (Optional) Enables SNMP VLAN-created traps.
vlandelete (Optional) Enables SNMP VLAN-deleted traps.

Cisco ME 3600X Specifications

General

Brand	Cisco
Model	ME 3600X
Category	Switch
Language	English