Cisco ME 3600X User Manual

-7
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter
snmp-server enable traps
Command Modes Global configuration
Command History
Usage Guidelines Specify the host (NMS) that receives the traps by using the snmp-server host global configuration
command. If no trap types are specified, all trap types are sent.
When supported, use the snmp-server enable traps command to enable sending of traps or informs.
Note Informs are not supported in SNMPv1.
To enable more than one type of trap, you must enter a separate snmp-server enable traps command
for each trap type.
SNMP transceiver traps apply to SFPs that support DoM-capable transceivers installed on the switch.
The sensor values are polled every 10 minutes, which is how often the user sees traps or alarms.
You can verify your setting by entering the show running-config privileged EXEC command.
Examples This example shows how to send MPLS traps to the NMS:
Switch(config)# snmp-server enable traps mpsl
Related Commands
Release Modification
12.2(52)EY This command was introduced.
Command Description
show running-config Displays the operating configuration.
snmp-server host Specifies the host that receives SNMP traps.

Cisco ME 3600X Specifications

General

Brand	Cisco
Model	ME 3600X
Category	Switch
Language	English