-89
Cisco ME 3800X and ME 3600X Switch Command Reference
OL-28238-01
Chapter
violate-action
Usage Guidelines You configure violate actions for packets that exceed the peak information rate (PIR).
The switch also supports marking multiple QoS parameters for the same class and simultaneously
configuring conform-action, exceed action, and violate-action marking.
Access policy-map class police configuration mode by entering the police policy-map class command.
See the police command for more information.
You can use this command to set one or more violate actions for a traffic class.
For both individual and aggregate policers, if you do not configure a violate action, by default the violate
class is assigned the same action as the exceed action.
You can verify your settings by entering the show policy-map privileged EXEC command.
Examples This example shows how configure multiple actions in a policy map that sets a committed information
rate of 5000000 bits per second (b/s) and a peak rate of 8000000 b/s:
Switch(config)# policy-map map1
Switch(config-pmap)# class class1
Switch(config-pmap-c)# police cir 5000000 pir 8000000
Switch(config-pmap-c-police)# conform-action transmit
Switch(config-pmap-c-police)# exceed-action set-dscp-transmit 24
Switch(config-pmap-c-police)# violate-action drop
Switch(config-pmap-c-police)# end
Related Commands Command Description
class Defines a traffic classification match criteria for the specified
class-map name.
conform-action Defines the action to take on traffic that conforms to the CIR.
exceed-action Defines the action to take on traffic between the conform rate and
the conform rate plus the exceed burst.
police Defines a policer for classified traffic.
policy-map Creates or modifies a policy map that can be attached to multiple
ports to specify a service policy.
show policy-map Displays quality of service (QoS) policy maps.
To Next Page
Loading...
Need help?
General