2201R Mobile Tester SCPI Reference Guide
Chapter 8 Configuration commands
47090/323
Copyright © 2016 Aeroflex Limited. All rights reserved.
115
:CONFigure:GPRS:BS:RLCMac:TFI
Syntax
:CONFigure:GPRS:BS:RLCMac:TFI <int1>
Parameters
int1 is an integer.
The minimum value for int1 is 0, the maximum value is 31. The default value for int1 is 0.
Description
This command sets the temporary flow identifier (TFI) in (asynchronous) generator/analyzer mode (please refer to
the description of the :CONF:CSYS:GPG command for further information).
Query
The query form of this command returns the current setting. The string delivered back contains one integer.
Example
:CONFigure:GPRS:BS:RLCMac:TFI 15
:CONF:GPRS:BS:RLCM:TFI?
Value returned: "15"
:CONFigure:GPRS:BS:RLCMac:BSN[:DATA]
Syntax
:CONFigure:GPRS:BS:RLCMac:BSN[:DATA] <int1>
Parameters
int1 is an integer.
The minimum value for int1 is 0, the maximum value is 127. The default value for int1 is 0.
Description
This command sets the block sequence number (BSN) in (asynchronous) generator/analyzer mode (please refer to
the description of the :CONF:CSYS:GPG command for further information).
The BSN is the absolute block sequence number modulo 128 of each RLC data block within the TBF. It is used to
enumerate the RLC data blocks, starting with 1.
Query
The query form of this command returns the current setting. The string delivered back contains one integer.
Example
:CONFigure:GPRS:BS:RLCMac:BSN:DATA 1
:CONF:GPRS:BS:RLCM:BSN?
Value returned: "1"
To Next Page
Loading...
Need help?
General